Aluminum Hood Prop

T- Handle Flat Tip
Diameter:.243" (1/4)" / 6.35 mm
Length: 14" / 35.5cm

Non slip 1.50" Rubber Flip Tip Attachment. Great for shrinking dents fast without leaving high spots. Fits all 5/16-18 threaded rods.

Also good for knocking down crowns.

The absolute best for roof rail hail damage! This mini slide will pull very strong, but is light enough that the tendency to OVER pull is GREATLY reduced.

One of the ways that seasoned hail techs are so fast is their lack of having to knock every pull pack down again. Pick up a TON of speed this year on your rail repairs with this mini slide.

The stainless steel slide on this hammer is 1.2 lbs. The complete hammer is 1.85 lbs and 14″ long. Slide has flat sides so it will not roll.  Lower handle is chromed aluminum.  Works with all popular glue tabs.

Length: 24" (60.9cm)
Diameter: 1/2" (1.27cm)
Includes: R4 tip

1/2” diameter double bend rod that accepts all the interchangeable tips we manufacture.

The pipe handle is perpendicular to the bends and threaded to accommodate one or two handle extensions, for added leverage.

The overall length of the bends is 4 inches (with a tip) and the combined angle is 80 degrees.

Note: A recommended use of the RDI24 would be to stack a combination of E1, E2, and E3 Extension Tips for putting your desired tip closer to the dent when leveraging off a front tire on fenders. This will also allow your hand to keep from hitting the tire when working.

Long Flag Diameter:.243 (1/4") / 6.35 mm
Length: 24" / 60.9cm
Flag: 4" / 10.1cm

Half Inch Tip w/ Soft Blue PVC 12/16" (3/4") Working Diameter

Dead Center® Crease Tabs.

• Patented Dead Center Technology - the specialized neck to face ratio provides the best possible rigid center pull with flex along the edges to avoid overpulling
• 70 x 7 mm Smooth Face - allows glue to adhere for the strongest possible pull
• Ice Material - extremely strong and rigid formula allows for incredible pull strength and maximum energy transfer

3" Silver Aluminum Knock Down w/ B4-P Tip