Tabtrax® 128mm Curved CentipedeAdapter

Gang Green Dead Center Tabs are the new kings for Hail Repair!

The dead center tabs have shown us that the most effective way to move metal is to flex with the metal as the repair is performed.

Using that knowledge, we have created the Gang Green dead center tabs using our battle tested firm but FLEXIBLE material. This allows the engineered flex to do it's job at an even higher level of effectiveness.

They can be pulled with a slide hammer or mini lifter, but start slow! You'll be surprised how well they can pull the center of the damage.

Length: 6”/ 15.2cm

Thickness of Shaft: .190" / 4.8mm

Width of shaft: .312”/ 7.9mm

Tip width: 1-1/8”/ 2.8cm

·       Retractable design                                                                                      

·       Able to extend from 34 to 50 cm and lock in place with a simple twisting action                                                       

·       The rubber caps on the rod will keep in place and from scratching.

·       Bonnet prop                                                                                                                                                                         

·       The tie down helps hold down panels on the hood prop

·       Ideal combination for locking panels in place while performing a repair

·       Ratchet capacity up to 75lb

This round Glexo v2 tab for PDR hail repair has a diameter of 25mm/ 0.98" and is used in PDR to work with Glexo hail cold glue. The tab is made of high-strength stainless steel, has a great appearance and high reliability. The working surface is polished to improve the adhesion of PDR cold glue, which eliminates its separation from the tab during operation. The tab is equipped with a patented proprietary quick fastening system with an O-ring for reliable and quick fixation. Fastening to the slide hammer is simple and intuitive, it is carried out by twisting movements after inserting the asymmetric nut of the tab into the seat of the slide hammer.

3" Wire handle hand tool
Diameter:3/16" (4.76mm)
Length: 3" (7.62cm)

• Sharp Side Panel Hook 1'' Curve Flag
• Sharp Side Panel Hook 2 1-1/2'' Curve Flag
• Sharp Side Panel Hook 3 2'' Curve Flag
• Sharp Side Panel Hook 4 2-1/2'' Curve Flag
• Sharp Side Panel Hook 5 3'' Curve Flag
• Sharp Side Panel Hook 6 3'' Curve Flag

Non slip 1.50" Rubber Flip Tip Attachment. Great for shrinking dents fast without leaving high spots. Fits all 5/16-18 threaded rods.

Also good for knocking down crowns.